Home > Cannot Allocate > Error V-5-1-435 Cannot Allocate Space

Error V-5-1-435 Cannot Allocate Space

Contents

V-5-0-0 2a: Received invalid message block in TCP stream Ignore message if seen occasionally. V-5-0-0 Disconnecting rlink rlink_name due to loss of TCP connection V-5-0-0 Disconnecting rlink rlink_name due to stream error V-5-0-0 Disconnecting rlink rlink_name due to header checksum error V-5-0-0 Create/Manage Case QUESTIONS? V-5-0-75 Cannot open ktli (errno) Ignore message if seen occasionally. have a peek at this web-site

V-5-0-107 Detaching rlink rlink_name due to I/O error on remote SRL during recovery When the original Primary comes up after it has been taken over, an I/O error has occurred on Action: If the message persists, contact Veritas Customer Support. You may not have followed the proper procedure for upgrading VVR as described in Release Notes. Create a new plex using 1st Subdisk bash-3.00# vxmake -g mohidg sd mohidg_d02 mohidg01,1024000,1001472bash-3.00# vxmake -g mohidg plex mohidg_pl01 sd=mohidg_d01bash-3.00# vxprint -stg mohidgSD NAME PLEX DISK DISKOFFS LENGTH [COL/]OFF DEVICE MODESV

Vxvm Vxresize Error V-5-1-4703

CALL US: 1 (866) 837-4827 Solutions Unstructured Data Growth Multi-Vendor Hybrid Cloud Healthcare Government Products Backup and Recovery Business Continuity Storage Management Information Governance Products A-Z Services Education Services Business Critical Action: No action is required. If the errors persist, they may indicate a problem with the network configuration. V-5-0-0 Size of primary SRL ("VOFFDSTR") does not match size wth secondary SRL" Indicates that the size of the SRL on the bunker secondary does not match the size of the

c2t4d0 /[email protected],0/pci15ad,[email protected]/[email protected],0 6. Create a Volume of 1 GB bash-3.00# vxassist -g mohidg make mohi_vol02 1g 2. When the original Primary comes up after it has been taken over and the application on the original Primary tries to perform writes, the writes will fail because this RVG is V-5-0-611 Could not send heartbeat id to node node V-5-0-174 header checksum error V-5-0-175 Heartbeat unacknowledged from node ip-addr for t seconds V-5-0-206 listen server port in use

Remove a disk and try to add new disk and restore the vxconfigrestore # vxconfigrestore -p mohidg (Applied mode like preview) # vxconfigrestore -d mohidg (Abort the applied mode restore) # No Yes Did this article save you the trouble of contacting technical support? Some of the RLINKs will be disconnected. The failed drive in the disk group must be replaced and the log will then be re-initialized on the new drive.

Action: For replication to take place, all the hosts in the VVR configuration must be running the same version of VVR. Action: Start the volumes in the secondary rvg and then connect the rlink. V-5-0-54 Cannot find any free port to bind All the ports in the specified list have been utilized. Related About jeanwan DBA View all posts by jeanwan → This entry was posted in VCS.

Vxvm Vxassist Error V-5-1-436 Cannot Allocate Space To Grow Volume

I've tried it in a test-environment: Code: [email protected] # vxdisksetup -i c3t54d0 [email protected] # vxdg init testdg testhd=c3t54d0 [email protected] # vxassist -g testdg maxsize Maximum volume size: 5681152 (2774Mb) [email protected] # Action: If the message persists, contact Veritas Customer Support. Vxvm Vxresize Error V-5-1-4703 It will be detached and marked stale. How To Increase Striped Volume In Vxvm This can be avoided in the future by using the RLINK's srlprot attribute.

V-5-0-79 cannot recover vol vol_name A memory allocation failure occurred during a cluster reconfiguration. http://tcsmacs.net/cannot-allocate/ioexception-error-12-cannot-allocate-memory.php Learn advanced UNIX, UNIX commands, Linux, Operating Systems, System Administration, Programming, Shell, Shell Scripts, Solaris, Linux, HP-UX, AIX, OS X, BSD. V-5-0-51 Cannot connect to remote due to header format mismatch or checksum error Action: Contact Veritas Customer Support. Search for: Recent Posts Resource usage check onHPI EM 12c configurationrecords Remove gns and reconfigureSCAN/vip Block multicast packets by usingIPFilter Restore ocr andvotedisk Recent Comments HA NFS solution usin… on nfs

Action: Add the ports to be used for replication using the vrport command. Find all posts by pressy « Previous Thread | Next Thread » Thread Tools Show Printable Version Email this Page Subscribe to this Thread Display Modes Linear Mode Switch No Yes Did this article save you the trouble of contacting technical support? http://tcsmacs.net/cannot-allocate/linux-error-12-cannot-allocate-memory.php If there were no error messages from the disk driver, contact Veritas Customer Support.

V-5-0-348 vol_rp_set_state_atomic_commit_done:cannot log atomic commit state for rvg rvg_name V-5-0-349 vol_rp_set_state_atomic_commit_start: cannot log atomic commit state for rvg rvg_names Prev Up Next Kernel messages Home Informational messages VxVM Friday, March I like it very much that , there are many many things i learned by reading it which i was thinking are not possible before reading this Book. Reduce the Volume using vxassist by 500 MB bash-3.00# vxassist -g mohidg shrinkby mohi_vol02 500mVxVM vxassist ERROR V-5-1-7236 Shrinking a FSGEN or RAID5 usage type volume can result in loss of

Expected message with opcode operation-code, received opcode operation-code V-5-0-0 Data checksum error for handshake message id (message-id), data checksum computed (checksum-value) but header contains (checksum-value) V-5-0-0 Data checksum error.

The attempted write to the log failed either because the kernel log is full or because of a write error to the drive. Jeanwan's Blog Just another WordPress.com site Skip to content HomeAbout ← FILESPERSET in RMANBACKUP iSCSI configuration → VxVM vxassist createERRORs Posted on April 21, 2010 by jeanwan [email protected] # vxassist -g If you can, I feel that it would be one of the "disk" type commands rather than a "volume" type command. Menu Close Search SOLUTIONS Solutions Overview Unstructured Data Growth Multi-Vendor Hybrid Cloud Healthcare Government PRODUCTS Product Overview Backup and Recovery Business Continuity Storage Management Information Governance Products A-Z SERVICES Services Overview

Rather than merely showing how to use Storage Foundation, it explains why to use it in a particular way, along with what goes on inside. Alternatively, you can specify nlog=1 in the vxassist make or vxassistaddlog command. V-5-0-102 DCM volume vol name is detached The DCM volume became detached because a DCM log entry cannot be written. have a peek here Action: Refer to the latest Release Notes for the correct upgrading procedures.

Action: If the message persists, contact Veritas Customer Support. Action: Ignore message if seen occasionally. V-5-1-435 Cannot allocate space for 20480 block volume or not enough disks for creating dcm with 2 mirrors By default, the DCM is mirrored; therefore, it requires space on two disks. Remote is now a primary rvg.

No Yes How can we make this article more helpful? Understand spare disk behaviour Watermark template. The RLINKs will go into the STALE state. No Yes Menu Close Search SOLUTIONS Solutions Overview Unstructured Data Growth Multi-Vendor Hybrid Cloud Healthcare Government PRODUCTS Product Overview Backup and Recovery Business Continuity Storage Management Information Governance Products A-Z SERVICES