Home > Cannot Be > Connection To The Server Cannot Be Established Unknown Error

Connection To The Server Cannot Be Established Unknown Error

Contents

Format may be off, but I believe that is the general format. Conditions: Centralized TFTP with CUCM 8.X and Security By Default with ITL files installed on the phones. Bob Fronk From: Bill Talley [mailto:btalley [at] gmail] Sent: Friday, April 24, 2009 12:44 PM To: Bob Fronk Cc: cisco-voip [at] puck Subject: Re: [cisco-voip] Call Manager - Control Center pages New web sessions time out after 5 minutes. have a peek at this web-site

Also, if you are going to have other DNs for the IP originated callers, not the warm transfer with queuing calls, then use the non-MTP trunk on that route pattern. Meridian Street, Suite 225 Carmel, IN 46032 317.569.4255 Office 317.569.4201 Fax 317.694.6070 Cell dennis.heim [at] cdw www.berbee.com From: cisco-voip-bounces [at] puck [mailto:cisco-voip-bounces [at] puck] On Behalf Of Bob Fronk In few cases, if the DB is corrupted then a rebuild of CUCM is necessary. Lastly, it is necessary to create an alternate SIP Trunk Security Profile, apart from the default one “non secure sip security profile”.

Cucm Page Cannot Be Displayed

If you use a self-signed certificate on the affected server, regenerate the Tomcat certificate with the set cert regen tomcat command from the CLI or from OS Admin and then restart Event ID 7011 Timeout (30000 milliseconds) waiting for a transaction response from the Cisco CallManager service. You can use the '?' after 'utils services' for additional info on starting/restarting individual services. You are able to log in to the CUCM Admin web page from Subscriber, but any changes on CUCM cause one of these errors: 'Error occurred while retrieving information from database.

HTH Bill On Fri, Apr 24, 2009 at 11:31 AM, Bob Fronk <bob [at] btrfronk> wrote: When I go to the Unified Serviceability and select "Tools - Control Center HTH Bill On Fri, Apr 24, 2009 at 11:31 AM, Bob Fronk <bob [at] btrfronk> wrote: When I go to the Unified Serviceability and select "Tools - Control Center There were no unknown protocol drops and no output drops during the last 60 minutes. Call Manager Web Interface Not Working Guess I am headed for a restart of the whole server?

admin:set webapp session timeout 5 If you continue with this operation, it sets the session-timeout for web sessions to 5 minutes after the Cisco Tomcat service has been restarted or after Connection To The Server Cannot Be Established(unable To Access Remote Node) Bob Fronk From: Bill Talley [mailto:btalley [at] gmail] Sent: Friday, April 24, 2009 12:44 PM To: Bob Fronk Cc: cisco-voip [at] puck Subject: Re: [cisco-voip] Call Manager - Control Center pages Bob Fronk From: Bill Talley [mailto:btalley [at] gmail] Sent: Friday, April 24, 2009 12:44 PM To: Bob Fronk Cc: cisco-voip [at] puck Subject: Re: [cisco-voip] Call Manager - Control Center pages So if it’s configured you will get the output in the show tech. #bsoft-bangalore, #ccie-rs, #ccie-security, #ccie-service-provider, #ccie-storage, #ccie-voice, #ccie-wireless, #download, #hot-issues-in-cisco-tac, #ipcc-enterprise Bsoft Bangalore 4:08 pm on August 22, 2011

If the problem occurs again, contact the TAC with these logs: Call Manager (Detailed) Traces Tomcat Logs (logs from output of the file get activelog tomcat/logs/* command from the CLI) Event Cisco Call Manager Web Interface Download the cert: ipsec-trustIn the sub your having the issue1. You can use the '?' after 'utils services' for additional info on starting/restarting individual services. show interfaces history *is* included in the show tech-support.

Connection To The Server Cannot Be Established(unable To Access Remote Node)

Opening defect so that the the precise error on the ccmservice logs can be passed on to the web page. This issue has been fixed in versions of CUCM 9.1.2.11900-10 and later. Cucm Page Cannot Be Displayed Is database running? Connection To The Server Cannot Be Established Certificate Exception Bob Fronk From: Bill Talley [mailto:btalley [at] gmail] Sent: Friday, April 24, 2009 12:44 PM To: Bob Fronk Cc: cisco-voip [at] puck Subject: Re: [cisco-voip] Call Manager - Control

Dennis Heim Network Voice Engineer CDW Advanced Technology Services 11711 N. Check This Out The error/symptom on Subscriber is different because Subscriber uses its own A Cisco DB process which runs fine. both (Optional) Specifies both the input histograms and the output histograms. You can set the web page timeout with these commands from the CLI of CUCM. Cucm Restart Tomcat

I passed my CCIE Lab!!! Was this Document Helpful? Bob Fronk From: Wes Sisk [mailto:wsisk [at] cisco] Sent: Friday, April 24, 2009 2:51 PM To: Bob Fronk Cc: Dennis Heim; Bill Talley; cisco-voip [at] puck Subject: Re: [cisco-voip] Call Manager Source Problem 8: Web Page Logs Out Automatically The CUCM web page logs out automatically after its idle timeout expires.

from CLI: utils service list is "A Cisco Db" running? Cscup10995 All rights reserved. but hindsite I guess.....

You can use the '?' after 'utils services' for additional info on starting/restarting individual services.

Might be a good time to open a Cisco TAC case to get some formal investigation going on. What impact will it have on my users? what is the best way to perform a restart either from CLI or Web Interface? Cucm Gui Not Working Service Manager is runningCisco Tomcat[STOPPING]Cisco Tomcat[STOPPING]Cisco Tomcat[STOPPING]Cisco Tomcat[STOPPING]Commanded Out of ServiceCisco Tomcat[NOTRUNNING]Service Manager is runningCisco Tomcat[STARTING]Cisco Tomcat[STARTING]Cisco Tomcat[STARTED] The Cisco Tomcat service restarted successfully.

You might want to start downloading the RecoveryCD for your version of CM just in case. Reset all phones to verify they download the new ITL file that will disable ITL signature verification. 4. show webapp session timeoutset webapp session timeout admin:set webapp session timeout ? have a peek here This will allow you to only use MTP allocation on the warm transfers with queueing.

I would not be comfortable making your inference. The range is 5 to 99999. from CLI: utils service list is "A Cisco Db" running? View Bug Details in Bug Search Tool Why Is Login Required?

Check for any Tomcat certificate (tomcat-trust) serial number mismatches on the nodes. Dennis Heim Network Voice Engineer CDW Advanced Technology Services 11711 N. Guess I am headed for a restart of the whole server? If expired, regenerate the Tomcat certificate and restart the Tomcat service.

Workaround Log in to each CUCM node separately in order to access Serviceability and Activate/Deactivate services. Problem 7: Unable to Access ELM with Firefox and Chrome You are unable to access Enterprise License Manager (ELM) with Firefox and Chrome, but this works fine with IE. However, it has been noticed that the copy/paste function still works with a few versions of CUCM 10.x, which is documented in Cisco bug IDs CSCus84153 and CSCus84152. Contact Gossamer Threads Web Applications & Managed Hosting Powered by Gossamer Threads Inc.   Search for:Search Want your own MarkMail?

Problem 9: Unable to Access the Admin/User Web Page of CUCM You are unable to access the Admin/User web page of CUCM. Is database running? You can use the '?' after 'utils services' for additional info on starting/restarting individual services. and Canada Service Order Returns Cisco Router Configure QoS Template Cisco Routers that Support NetFlow Cisco Sales Office Locator Cisco Secure Business Advisor Cisco Security Agent ROI Calculator Cisco Security Center

Send to Email Address Your Name Your Email Address Cancel Post was not sent - check your email addresses! The output rate histogram shows that the output rate reached 8 Mbps twice; once 7 minutes prior and the second time 26 minutes prior to the command execution. What impact will > it have on my users? > > > > > > > > *Bob Fronk* > > > > > > > > > > > > Would a backup complete if the DB was hung?

Bob Fronk From: Bill Talley [mailto:btalley [at] gmail] Sent: Friday, April 24, 2009 12:44 PM To: Bob Fronk Cc: cisco-voip [at] puck Subject: Re: [cisco-voip] Call Manager - Control Center pages At this point the database is likely hung, that is the most common culprit for ServM hangs. The TCP session stays in the ESTABLISHED state on the server. ‘netstat -an’ on the server will show the TCP session on the server.